Erp-Ring Guard-Timer - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Ethernet Ring Protection Commands

erp-ring guard-timer

Configures the guard timer value for the specified ERP ring node. The guard timer is used to prevent ring
nodes from receiving outdated Ring Automatic Protection Switching (R-APS) messages. During the
amount of time determined by this timer, all received R-APS messages are ignored by the ring protection
control process.
erp-ring ring_id guard-timer guard_timer
no erp-ring ring_id guard-timer
Syntax Definitions
ring_id
guard_timer
Defaults
parameter
guard_timer
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to set the timer back to the default value of 50 centi-secs.
•
The specified ring ID must already exist in the switch configuration.
Examples
-> erp-ring 1 guard-timer 10
-> no erp-ring 1 guard-timer
Release History
Release 7.1.1; command was introduced.
Related Commands
erp-ring
show erp
MIB Objects
alaErpRingId
alaErpRingGuardTimer
OmniSwitch CLI Reference Guide
An existing ERP ring ID number. The valid range is 1–2147483647.
The guard timer value. The valid range is 1–200 centi-secs.
default
50
Configures an ERP ring.
Displays the ERP ring configuration for the switch.
March 2011
erp-ring guard-timer
page 8-9