Kyocera TASKalfa 7002i Service Manual page 799

U610 System 1
(Message: System Setting 1)
Contents
Set the number of lines to be ignored when receiving a fax at 100% magnification and in the auto
reduction mode.
Method
1.Press the [Start] key.
2.Select the item to set.
Items
Cut Line: 100%
Cut Line: Auto
Cut Line: A4
Setting: Cut Line(100%)
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when recording the data at 100% magnification.
If the number of excess lines is below the setting, those lines are ignored. If it is over the setting,
they are recorded on the next page.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Set the number of lines to be ignored when receiving a fax
at 100% magnification.
* :Increase the setting value if a blank second page is output in the full magnification reception.
Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Setting: Cut Line: Auto
Set the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Number of lines to be ignored when receiving in the auto
reduction mode.
* :Increase the setting value if a page received in the reduction mode is reduced too much with
the trailing edge margin. Decrease the value if there is dropout in received image.
Set the number of lines to be ignored when receiving a fax at 100%
magnification.
Number of lines to be ignored when receiving in the auto reduction
mode.
Set the number of lines to be ignored when receiving a fax (A4R/Let-
terR) in the auto reduction mode.
Contents
Contents
6-206
Contents
Setting
range
0 to 22
Setting
range
0 to 22
2WA/2NJ/2RK
Data Initial
varia- setting
tion
- 3
Data Initial
varia- setting
tion
- 0