Kyocera TASKalfa 7002i Service Manual page 967

Step Check description
10 Checking the paper feed
motor
11 Checking the drive parts
J0501/J0502: No paper feed from the cassette
Condition: The paper leading edge passes the feed pulley.
After the feed clutch turns on during paper feed from cassette 1, 2, the paper leading edge comes out from the
cassette but the feed sensor does not turn on.
Step Check description
1 Checking the feed pulley
2 Checking the pressure
release lever and the
retard holder
3 (When the paper skew
occurs) Relocating the
paper width guides
4 (When the paper skew
occurs) Checking the actu-
ator and the spring
5 (When the paper skew
occurs) Checking the con-
veying guide
6 (When the paper skew
occurs) Checking the
paper path
Assumed cause
The feed motor does not
properly operate.
The drive from the feed
motor is not properly trans-
mitted.
Assumed cause
Conveying capability of the
feed pulley is not enough.
The press-release lever
and the retard holder are
attached oppositely.
The locations of the paper
width guides do not fit with
the paper size.
The actuator does not
operate properly.
The paper is caught with
the conveying guide.
The paper is caught with a
piece of paper, etc.
7-107
Measures
Execute U030 [Feed]. If the
feed motor does not properly
operate, reattach it and rein-
sert the connector. If not
repaired, replace it.
Reattach the drive parts of
the feeding motor. If not
repaired, replace the parts
faulty in operation. Or replace
the feed drive unit.
Measures
Clean the feed pulley sur-
face. If it is worn down,
replace it.
Reattach the pressure
release lever and the retard
holder.
Relocate the paper width
guides to fit them with the
paper size.
The actuator or the spring is
deformed, or if not properly
operate, replace it.
Reinstall the conveying
guide. If there are burrs on
the conveying surface of the
conveying guide, remove
them. If not repaired, replace
it.
A piece of paper or the for-
eign objects are adhered on
the conveying path, or if the
parts such as the guide or
the actuator has burrs,
remove them.
2WA/2NJ/2RK
Reference
U030 Exe-
cution
Detaching
and Reat-
taching the
feed drive
unit
Reference
Detaching
and reat-
taching the
pickup pul-
ley, feed
pulley and
retard pul-
ley