Kyocera TASKalfa 7002i Service Manual page 578

(2) Option
(2-1)PF-730(B)
Parts name
A <Set up>
1 PAPER LINE
B <Paper feed>
From initial production to new parts launch
1 PARTS PRIMARY FEED UNIT HI SP
After new parts launch
2 PULLEY FEED
Paper feed X4
3 PULLEY RETARD
Separation X2
4 PULLEY PICKUP
Forward X2
5 PARTS ROLLER CONVEYING VF SP
6 PARTS ROLLER FEED LOW SP
7 PARTS ROLLER ASSIST SP
8 CLUTCH 50 Z35R
*:If replaced at check, return to the original maintenance at the next maintenance. If not replaced at check, check again at the next maintenance.
PM maintenace (x1000 counts)
Parts No.
Set up User Call
-------- CH
AD
302NJ94110 CH
2NJ94110 CL
302N406030 CL
2N406030
302N406040 CL
2N406040
302N406030 CL
2N406030
303NF94070
3NF94070
302K994430
X2 2K994430
303NJ94050
X2 3NJ94050
302KV44041 CH
X2 2KV44041 RE
*Based on the main
*
installation
CH: Check the image center alignment gap
(Check after the center adjustment of copier.)
CH CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
RE
CH CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
RE
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth
CL CL: Alcohol or dry cloth
CL CL: Alcohol or dry cloth
CH CH: Check the paper feed status.
4-250
CH:Check / CL:Clean / AD:Adjust / LU:Lubrication / RE:Replace
Remark
Please do not use spray containing flammable gas for air-blow or air-brush purposes.
The following parts are installed depends on the unit.
2WA/2NJ/2RK