Kyocera TASKalfa 7002i Service Manual page 707

U203 Check DP operation
(Message: Check DP Operation)
Contents
Simulate the original conveying operation separately in the DP.
Purpose
Check the DP operation
Method
1.Press the [Start] key.
2.Place an original in the DP if running this simulation with paper.
3.Select the scan speed
Items
Normal Speed
High Speed
Mode
Reset
Result
Method: Normal Speed/High Speed
1.Select the item to operate.
Items
CCD ADP
CIS
CCD ADP (Non-P)
CIS(Non-P)
2.Press the [Start] key.
* :The operation starts.
3.To stop the operation, press the [Stop] key.
Setting: Mode
1.Select the item to set.
Items
On
Off
2.Press the [Start] key to set the setting value.
Method: Reset
1.Select [Execute].
2.Press the [Start] key to reset.
Method: Result
1.Displays the conveying timing data.
Completion
Press the [Stop] key.
The screen for selecting a maintenance item No. is displayed.
Normal scanning (600dpi)
High speed scanning
Set the conveying timing inspection mode
Reset the conveying timing inspection data
Check the conveying timing
With paper, a single-sided original is fed to the CCD
With paper, a double-sided original is fed to the CIS
Without paper, a single-sided original is fed to the CCD (continuous
operation)
Without paper, a double-sided original is fed to the CIS (continuous
operation)
Set the conveying timing inspection mode to On
Set the conveying timing inspection mode to Off
6-114
Contents
Contents
Contents
2WA/2NJ/2RK