Kyocera TASKalfa 7002i Service Manual page 597

Section No.
Devel- U139 Temperature, humidity
oper sys-
tem
U140 Developer bias adjustment
U147 Setting the toner applying mode
U148 Drum refresh mode setting
U155 Toner sensor output
U156 Toner control level adjustment
U157 Developer drive time
U158 Developer counter
Fuser U161 Fuser temperature adjustment
U164 Developer unit history
U165 Fuser unit number
U167 Clearing the fuser count
U169 Setting the fuser power source
U193 Fuser drive control setting
U198 Fuser phase control setting
U199 Fuser temperature
Opera- U200 All LEDs lighting
tion sec-
U201 Initializing the touch panel
tion /
Support
U203 Check DP operation
equip-
ment
U204 Key card/key counter setting
U206 Sets the coin vendor
U207 Operation key check
U208 Setting the paper size for the side
deck
U221 USB host lock function setting
U222 Setting the IC card type
U223 Operation panel lock
U224 Setting Original Panel Display
U230 Optional device serial number
U234 Setting destination for punch
U237 Finisher eject volume limit
U240 Finisher operation check
U241 Finisher switch check
Maintenance item
Displays the machine inside and outside humid-
ity
Adjust the developer bias values or set the high
altitude mode.
Sets the overcharge toner removal mode
Setting auto drum refresh
Displays the toner sensor output
Displays/adjusts the toner supply level
Displays/sets the developer drive time
Displays/sets the developer counter
Sets the fuser control temperature
Displays the machine number and the fuser unit
history
Displays the fuser unit number
Displaying/clearing the counts
Displays/sets the IH PWB control voltage
Change fuser drive control setting
Change the fuser phase control.
Monitor the fuser temperature
Light all the LEDs on the operation panel
Correct the X and Y axis position of the touch
panel
Checking the DP paper conveying operation
with the DP alone
Key card/key counter connection setting
Sets the coin vendor
Check the operation panel key operation
Set paper size of side feeder
Sets USB Host lock function ON/OFF
Sets the ID card type
Set On/Off of the operation unit lock
Sets the opening screen
Displays the optional device serial number
Set the punch destination
Sets the main tray stack capacity
Checks the drive operation
Check the switch operation
6-4
2WA/2NJ/2RK-2
Outline