7.Wind the outer scanner wires around the outside grooves in the pulleys of the mirror frame 2
from above to below. (7)
*: The scanner wires pass the outside of positioning pin.
8.Hook the round terminals (without red marking) to the catches inside the scanner unit. (8)
9.Wind the inner scanner wires around the grooves in the pulleys at the left of the scanner unit
from below to above. (9)
*: Align the scanner wires along the lower side of the mirror frame 2.
10.Wind the scanner wires around the inside grooves in the pulleys of the mirror frame 2 from
below to above. (10)
11.Wind the scanner wires around the grooves in the pulleys at the left of the scanner unit. (11)
12.Hook the round terminals (with red marking) to the scanner wire springs. (12)
13.Apply the procedures 6 through 12 to another scanner wires.
Scanner wire
stoppers
Red marking
mirror frame 2
Gray
Scanner wire drums
Five turns
outward
Three turns
inward
Figure 4-179
4-119
Black
Screws
Three turns
Locating ball
inward
2WA/2NJ/2RK
Scanner wire
stoppers
Five turns
outward
14e0263