Kyocera TASKalfa 7002i Service Manual page 700

U169 Setting the fuser power source
(Message: Set Fuser Power Source)
Description
Displays and sets the control voltage specification of the IH PWB.
Purpose
Execute to check the control voltage specification
* :When U021 is executed, set to the same voltage specification as the IH PWB.
Execution
1.Press the [Start] key.
2.Select the item to set.
Items
Set Fuser
CT Mode*
* : Not used for this model
Setting: Set Fuser
1.Change the setting value by using [+] [-] key or the numeric keypad.
Items
Mode
2.Press the [Start] key and then fix the setting.
Setting: CT Mode
1.Select the item to set.
Items
On
Off
2.Press the [Start] key and then fix the setting.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Set fuser unit destination
Current sensor mode setting
Contents
Set the fuser unit destination
Current sensor mode setting On
Current sensor mode setting Off
6-107
Contents
Setting range
1: 100V specifi-
cations
2: 200V specifi-
cations
3: 120V specifi-
cations
4: 110V specifi-
cations
Contents
2WA/2NJ/2RK-1
Initial setting
-
(Destination)