13. Open the document processor.
14. Remove the original mat (a).
15. Place original mat (a) with its Velcro (b)
upward over the contact glass.
*: Align original mat corner that has 90
degrees of angle with the rear left cor-
ner of the original instruction panel.
16. Close the DP (c) and attach the original
mat (a) onto DP (c) with Velcro.
17. Make a test copy again.
18. Repeat the steps 1 to 16 until the gap of
the trailing edge falls within the Refer
ence values.
a
b
a
Figure 4-334
4-220
2WA/2NJ/2RK
c
b
14j0518