Kyocera TASKalfa 7002i Service Manual page 752

U340 Setting the applied mode
(Message: Set Applied Mode)
Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a
working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct print-
ing occurs.
Execution
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Items
Adj Memory
Adj Max Job
Adj Custom Box
Adj Hypas Application Set the partition size of Hypas Application
setting: Adj Memory
1.Change the setting value by using [+] [-] key or the numeric keypad.
Items
Image
* :Set the values below in case print failure occurs with the memory shortage. (recommended
value)
Image : +100
* :The work area for copy is small and it may cause output failure if the values are large.
2.Press the [Start] key. Set the setting value.
3.Turn the power switch off then on. Wait more than 5 seconds between the power off and on.
Setting: Adj Max Job
1.Change the setting value by using [+] [-] key or the numeric keypad.
Items
Copy
Printer
* :The maximum [Printer] jobs should be (maximum jobs) – (maximum copy jobs).
2.Press the [Start] key. Set the setting value.
Sets the memory allocation
Setting the maximum of multiple jobs
Set the partition size of Custom Box
Contents
Area temporarily used to create output image. -100 to
Contents
Maximum copy (Scan To Print) Jobs
Maximum printer (Host To Print) Jobs
6-159
Contents
Setting
range
100(MB)
Setting
range
10 to 50
10 to 50
2WA/2NJ/2RK
Initial setting
0
Initial setting
10
-