Kyocera TASKalfa 7002i Service Manual page 687

Setting: Mag Duty
1.Select the item to set.
2.Change the setting value by using [+] [-] key or the numeric keypad.
Items
Normal Developer sleeve roller duty
3.Press the [Start] key to set the setting value.
Setting: AC Calib
1.Select the item to set.
* :The screen for setting is displayed.
Items
Calibration
Magnification*1
Setting: Calibration
1.Select the item to set.
2.Changes the developer to execute AC calibration.
Items
K Switches Black developer on/off
Type High altitude grain mode setting
Execute Executing Calibration
* :When the density of solid image is dropped, set to "Type: +1". (High altitude grain mode)
3.Select [Execute].
4.Press the [Start] key. AC calibration is started.
5.Turn the power switch off then on. Wait more than 5 seconds between the power off and on.
* :An error code appears when there is an error.
Contents
Executing AC Calibration (Developer AC bias setting)
Execution timing
1. Setup at high altitude
2. When replacing the developer unit or drum unit
3. When the developer leakage occurs
4. When the solid image density is low after executing the AC calibra-
tion
Setting the AC calibration target bias value
Execution timing
1. When the developer leak occurs after executing the AC calibration
Contents
6-94
Setting range Data
variation
1 to 99
Contents
Setting range Data
variation
0: Off / 1: On
0 to 2
-
2WA/2NJ/2RK
Initial
setting
- 68
Initial
setting
- -
- 0
- -