Kyocera TASKalfa 7002i Service Manual page 766

Items
DP Use when setting
FU(ChartB) up DP or executing
U021 initialization
DP
FD(ChartB)
Target
DP Auto Adj
Method: Table (Chart A)
Automatic input of the target value
* :Usually, it adjusts here.
1.Set the specified original (P/N: 7505000005) on the table.
2.Enter maintenance item U411.
3.Select [Target].
4.Select [Auto].
5.Press the [Start] key.
6.Select [Table(ChartA)].
7.Press the [Start] key to read the barcode of the original chart and to start the automatic adjust-
ment.
8.When automatic adjustment has normally completed, [OK] is displayed.
*: When the error code "1e" or "1f" is displayed during the automatic adjustment in the table scanning and
the barcode is not read, adjust the following after manually inputting the target value.
Manual input of the target value
1.Enter the target values which are shown on the lower part of the front page of the adjustment
original (P/N: 7505000005) by executing the maintenance mode U425.
2.Set the specified original (P/N: 7505000005) on the table.
3.Enter maintenance item U411.
4.Select [Target].
5.Select [U425].
6.Press the [Start] key.
7.Select [Table(ChartA)].
8.Press the [Start] key to start Auto adjustment.
9.When automatic adjustment has normally completed, [OK] is displayed.
If the image position is shifted largely at the DP adjustment below, an error might occur when
adjusting it with ChartA. First, use ChartB (image position) to adjust it and then use ChartA
(color).
Use
Execute the 1st side automatic
adjustment in the DP scanning sec-
tion.
Execute the 2nd side automatic
adjustment in the DP scanning sec-
tion.
Magnification in the sub-scanning
direction
Leading edge timing
Center line
Trailing edge timing
Set-up for obtaining the target value
Adjusting the document processor
scanning section with the chart out-
put by the local machine
Magnification in the sub-scanning
direction
Leading edge timing
Center line
Contents
6-173
2WA/2NJ/2RK
Original for adjustment
(P/N)
302AC68243
7505000005
Without Chart B, executed in
a simplified manner.