(10-5) Adjusting the angle of leading edge
Perform the following adjustment if the leading edge of the copy image is laterally skewed.
Procedures
1. Place an original on the DP and press-
the [start] key to make a test copy.
2. If the gap of leading edge exceeds
theRefer ence value, perform the fol-
lowingadjustment.
Refer ence value
For simplex copying: Within ±3.0 mm
For duplex copying: Within ±4.0 mm
3. Loosen two screws (b) of right and left
fixing fittings (a).
Original
Copy Sample1
Figure 4-325
a
b
a
Figure 4-326
4-214
2WA/2NJ/2RK
3mm/4mm
3mm/4mm
Copy Sample2
a
14j0511
14j0512