Kyocera TASKalfa 7002i Service Manual page 469

SSD replacement procedures when the SSD replacement is indicated.
*: Data transfer by U026 is not available since data cannot be read when SSD is broken or it is in Read
Only mode.
Procedures
Preparation: 2 USB memory (for firmware and data backup)
Before operating, perform data backup in U917.
(1)Firmware storage in a USB memory (USB memory A)
1. Store the latest firmware upgrade pack and released firmware set (Main /MMI /BROWSER /DICTIO-
NARY /Language /OCR) in a USB memory.
*: Check the firmware applicable to the target model. When inputting the software of outside the target,
becomes unstable in action.
In order to reboot, require minimum main.
(2)SSD data backup (USB memory B)
*: A 64GB USB memory is necessary to backup the 32GB SSD.
1. Install the USB memory B.
2. Execute maintenance mode U026.
Input "026" using the numeric keys and press the [Start] key.
Select [SSE].
Select [Backup]. Press the [Start] key.
Turn the power off after completion.
3. Replace the new SSD.
*: When equipping with SSD (8G/32G) which the capacity is different from the specification, pay attention
as F010 (SSD and communication error) happen.
4. Turn ON the power with equipping with USB memory A.
As the program from SSD can't load, SSD recovery program which is SNOR on the main PWB start up,
is formatted automatically.
*: When forgot the equipment of USB memory, pay attention as F010 displays.
5. If UPDATE completion is displayed on the control panel, turn OFF/ON the power with inserted USB
memory A.
(3)Update firmware. (See page 1-5-1)
(4)Retrieve the data backed up in the USB memory B.
(5)Install the HyPAS application (FMU, etc.) from the Application screen.
*: Confirm a kind of HyPAS application displayed with an application screen before SSD exchange, and
install it again.
4-141
2WA/2NJ/2RK