Kyocera TASKalfa 7002i Service Manual page 579

(2-2)PF-740(B)
Parts name
A <Set up>
1 PAPER LINE
B <Paper feed>
From initial production to new parts launch
1 PARTS PRIMARY FEED UNIT HI SP
After new parts launch
2 PULLEY FEED
Paper feed X4
3 PULLEY RETARD
Separation X2
4 PULLEY PICKUP
Forward X2
5 PARTS ROLLER CONVEYING VF SP
6 PARTS ROLLER CONVEYING DECK SP
X2
7 PARTS ROLLER ASSIST SP
X2
8 CLUTCH 50 Z35R
X2
*:If replaced at check, return to the original maintenance at the next maintenance. If not replaced at check, check again at the next maintenance.
PM maintenance (x1000 counts)
Parts No.
Set up User call
-------- CH
AD
302N294030 CH CH
2N294030 CL RE
302N406030 CL CH
2N406030 RE
302N406040 CL
2N406040
302N406030 CL
2N406030
303NF94070 CL
3NF94070
303NF94100 CL CL
3NF94100
303NJ94050 CL CL
3RC94070
302KV44041 CH CH
2KV44041 RE
*Based on the main
* Please do not use spray containing flammable gas for air-blow or air-brush purposes.
installlaion
CH: Check the image center alignment gap
(Check after the center adjustment of copier.)
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth (If no replacement)
CH: Check feeding count in simulation: Target to replace at 150K.
CL: Alcohol or dry cloth
CL: Alcohol or dry cloth
CL: Alcohol or dry cloth
CH: Check the paper feed status.
4-251
CH:Check / CL:Clean / AD:Adjust / LU:Lubrication / RE:Replace
Remark
The following parts are installed depends on the unit.
2WA/2NJ/2RK