Kyocera TASKalfa 7002i Service Manual page 782

U464 ID correction setting
(Message: Set ID Adjustment Mode)
Contents
Set permission/prohibition of the ID correction operation (calibration). Executes each setting of
the calibration.
Purpose
Execute the calibration setting when an image failure occurs or depending on the user's request.
Execute Calibration when replacing the maintenance kit.
Execution
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Items
Permission
Time Interval
Mode
On/Sleep Out
AP/NE
Leaving Time
Driving Time
Timing
Target Value
Calib
Setting: Permission
1.Select [On] or [Off].
Items
On
Off
* :Initial setting: On(1)
2.Press the [Start] key to set the setting value.
Permit/Prohibit Calibration
Sets the time interval to execute calibration after completing printing.
Calibration execution cycle setting
Calibration operation setting (start-up/recovery from sleep mode)
Calibration operation setting (AP/NE)
Setting the time to determine whether to execute calibration when recov-
ering from sleep mode
Setting the time to determine whether to execute between the paper cal-
ibration from driving time while printing.
Setting the execution timing by drive time
Setting the target sensor value for the toner thick layer calibration and
light intensity calibration
Executing Calibration
1: Permitting Calibration
0: Prohibiting Calibration
6-189
Contents
Contents
2WA/2NJ/2RK