Kyocera TASKalfa 7002i Service Manual page 779

Setting: DP(ChartB)
* :This setting is usually unnecessary.
Items
Lead Set the adjustment value of the
leading edge.
Main Scan Sets the adjustment value of the
left edge.
Sub Scan Set the adjustment value of the
trailing edge.
*1: Centimeter specification, 0*2: inch specification
1.Measure the distance "A" from the leading edge to the black belt (inside) on the adjustment
original.
2.Enter the value solved in "Lead" using the the [+] [-] keys keys.
3.Measure the distance "B" from the left edge to the black belt (inside) on the adjustment original.
4.Enter the values measured in "Main Scan" using the the [+] [-] keys keys.
5.Measure the distance "C" from the leading black belt (inside) to the trailing black belt (inside)
on the adjustment original.
6.Enter the values measured in "Sub Scan" using the the [+] [-] keys keys.
7.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
Main Scan
Original for adjustment Chart 2-2 (P/N: 302AC68243)
Figure 6-26
6-186
Setting range
14.0 to 16.0
0.56 to 0.63
14.0 to 16.0
0.56 to 0.63
388.0 to 392.0
15.28 to 15.43
Lead
Sub Scan
2WA/2NJ/2RK
Data Initial
variation setting
0.1mm 15.0
0.01 inch 0.6
0.1mm 15.0
0.01 inch 0.6
0.1mm 390.0
0.01 inch 15.36