Kyocera TASKalfa 7002i Service Manual page 396

(3-2) Detaching and reattaching the retard pulley
Procedures
1. Detach the PF paper feed unit (a).
2. Turn over the PF paper feed unit (a).
3. Remove two stop rings (c) from the
separation pulley shaft (b).
4. Pull out the spacer (d) from separation
pulley shaft and remove it.
*: Take care not to fall the set pin, when
removing the spacer.
5. Pull out the set pin (b) of torque limiter
(a).
6. Pull out the torque limiter (a) and PF
separation pulley shaft while pushing
Retard release lever (c), and remove it.
7. Clean or replace the PF separation pul-
ley.
8. Attach the PF separation pulley back
again to the PF feed unit.
9. Reattach the PF paper feed unit in the
original position.
IMPORTANT
When replacing the new pickup holder or retard holder, take care not to touch the roller surface.
d
d
a
b
4-68
2WA/2NJ/2RK
c
b
a
Figure 4-94
c
Figure 4-95
14j0108
14j0109