Removing And Installing Brake Shield Plates, Front Brake - Skoda Kodiaq 2017 Workshop Manual

– Remove the screw -arrow- and take off the brake disc.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Clean the surfaces for the brake disc and wheel hub.
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "1.1 Assembly overview - front brakes", page 45
♦ Wheel bolts ⇒ Running gear, axles, steering; Rep. gr. 44 ;
Wheels, tyres; Specified torque for wheel bolts .
1.5 Removing and installing brake shield
plates, front brake
Removing
– Remove wheel.
– Remove brake disc
⇒ "1.4 Removing and installing brake discs, front brake", page
54 .
– Remove screws -arrows-.
– Remove the cover plate -1- from the wheel bearing housing.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Clean the contact surfaces for the cover plate and the wheel
bearing housing.
WARNING
Do not flush the brake system with compressed air. The dust
that is generated is hazardous to health!
Tightening torques - summaries of components
Note
Replace bolts / nuts that are tightened at an angle of rotation, as
well as replacement components after removal.
♦ ⇒ "1.1 Assembly overview - front brakes", page 45
♦ Wheel bolts ⇒ Running gear, axles, steering; Rep. gr. 44 ;
Wheels, tyres; Specified torque for wheel bolts .
Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
55
1. Front brakes