Removing And Installing Engine Bracket - (Octavia Ili); Removing And Installing Engine Bracket - (Yeti) - Skoda Octavia III 2013 Workshop Manual

2.3 Removing and installing engine bracket
- (Octavia IlI)
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30119-
♦ Hook for MP9-200 and T30099 - MP9-200/10 (10-222A/10)-
♦ Adapter - MP9-200/18 (10-222A/18)-
♦ Support - 10-222A/31-3-
♦ Clutch - T40091/3-
Removing
– Remove the cooling water tank cover ⇒ Body Work; Rep. gr.
66 .
– Separate plug connection -1-.
– Unclip hose holder -2- from the coolant expansion tank.
– Unlock catches using a screwdriver -arrow- and lay coolant
expansion tank to the side.
– Remove caps of the screw connections of the front suspension
strut dome.
– Connect supporting device - T30099- as shown in the illustra‐
tion.
– Attach snap hook to the engine suspension eye, right.
– Slightly pre-tension engine/gearbox unit with the spindle, do
not raise.
– Release screws -arrows- and remove engine mount -1-.
Install
Install in the reverse order of removal. When doing this, note the
following:
– Check assembly bracket setting
Tightening torques
♦ Assembly bracket
⇒ "2.1 Assembly bracket - Summary of components (Octavia
III)", page 33
2.4 Removing and installing engine bracket
- (Yeti)
Special tools and workshop equipment required
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
⇒ page 41 .
1.6/81 kW MPI engine - Edition 06.2014
37
2. Assembly bracket