Dial-In Procedure - Compaq AlphaServer DS20E Reference Manual

6.4

Dial-In Procedure

To dial in on COM1, dial the modem, and type the escape sequence to
bring up the RMC. Use the hangup command to terminate the session.
A sample dial-in dialog would look similar to the following:
[Dial up]
CONNECT 9600
#
RMC V2.0
RCM>
Dial-In Procedure
1. Dial the number for the modem connected to the modem port. When the
connection is made, the "connect 9600" message
2. If you have set a password with the setpass command, a "#" (pound sign)
prompt is displayed. Enter the password. (If no password has been set, the
# prompt is not displayed.)
NOTE: It is recommended that you set a password. See Section 6.6.
You have three tries to correctly enter the password. After three incorrect
tries, the connection is terminated, and the modem is not answered again
for 5 minutes. When you successfully enter the password, the RMC banner
is displayed. You are connected to the system COM1 port, and you have
control of the SRM console.
NOTE: At this point no one at the local terminal can perform any tasks except
for typing the RMC escape sequence. The local terminal displays any
SRM console output entered remotely.
All manuals and user guides at all-guides.com
is displayed.
Remote Management Console 6-5