Measuring Tdso (Test Data Service Option) Frame Error Rate (Fer) - Agilent Technologies 8960 Series Operation Manual

Measuring TDSO (Test Data Service Option) Frame Error Rate
(FER)
1. Press the
CALL SETUP
2. If a call is currently connected, press the End Call key (
3. Press the Radio Config key (
4. Select one of the following radio configurations:
• (Fwd3, Rvs3)
• (Fwd4, Rvs3)
5. Press the FCH Service Option Setup key (
6. Select the Service Option for the currently selected radio configuration, then
select SO32 (+F-SCH).
7. Press the
Measurement selection
8. Select the TDSO Frame Error Rate measurement.
9. Press the TDSO FER Setup (
10.Set up the measurement parameters as needed for your measurement situation.
11.Press the
CALL SETUP
12.Press the Originate Call key (
13.Press the
MEASUREMENT
approximately 10 seconds for the measurement to begin. A typical display is
shown below.
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started
key.
).
F11
key.
) key.
F1
key.
).
F3
key. Wait for the call to connect, then wait
cdma2000 Measurement Procedures
).
F3
).
F12
77