Table of Contents
Advertisement
DC Power
Signal
BS Level
Timing ADV
Slot Config
Measured Slot
Sensitivity
Chapter 3
Input Field
Selects a supply mode. The choices are On and Off as follows:
o On: Always supplies dc voltage to the mobile.
b
o Off:
Disables to supply dc voltage to the mobile.
Accepts a dc voltage value
steps. This value is used among the AUTOMATIC TEST,
MANUAL TEST, SPECTRUM MONITOR, and SIGNAL
GENERATOR modes in common.
For synchronous mode tests, only Burst is valid and cannot be
changed.
Specifies the RF output level
to 50.0 dBm. The default value is set on the Test Condition screen
in the CONFIGURATION mode.
Accepts a value for the timing advance
Selects either 1 (downlink)
installed.
The order of measured slot is defaulted to 4 (fourth) if Option 040
is installed.
Displays BLER (block error rate) to make a sensitivity
measurement.
a. The variable increment softkey is activated. Refer to
ment Softkey" on page
b. When DC Power is set to Off, DC Current cannot be measured.
MANUAL TEST (GPRS Mode)
Description
a
ranging from 3.0 to 11.0 V in 0.1 V
a
of the Test Set, ranging from 110.0
a
1 (uplink) or 2
60.
Screen Reference
ranging from 0 to 63 bits.
1 if Option 040 is
"Variable Incre-
121
Advertisement
Table of Contents
