Figure 96: Installing A T320 Routing Engine; Figure 97: Reinstalling The T320 Routing Engine Cover - Juniper Core Router T Series Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
Press the Routing Engine cover into place, then tighten the captive screws on the
8.
corners of the cover to secure it to the chassis (see
If the router is powered on and the Routing Engine's corresponding control board is
9.
functioning normally, the Routing Engine comes online automatically. To verify that
the Routing Engine is installed correctly, check the
craft interface. If the router is operational and the Routing Engine is functioning properly,
the green LED lights steadily. If the red
OK
and install the Routing Engine again. If the red
Engine is not functioning properly. Contact your customer support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
For more information about using the CLI, see show chassis routing-engine.

Figure 96: Installing a T320 Routing Engine

Figure 97: Reinstalling the T320 Routing Engine Cover

T320 Routing Engine Description on page 33
Chapter 26: Replacing Host Subsystem Components
Figure 92 on page
and
HOST0 HOST1
LED lights steadily instead, remove
FAIL
FAIL LED still lights steadily, the Routing
219).
LEDs on the
223