Reinstalling T320 Components In The Chassis; Reinstalling The T320 Rear Fan Tray - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
Related
Documentation

Reinstalling T320 Components in the Chassis

Reinstalling the T320 Rear Fan Tray

142
NOTE: This illustration depicts the router being installed in a four-post rack.
For an illustration of the mounting hardware required for an open-frame rack,
see Figure 37 on page
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Router Installation Summary on page 107
Installing the T320 Router Using a Mechanical Lift on page 124
T320 Installation Safety Guidelines on page 335
After the T320 router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
Reinstalling the T320 Rear Fan Tray on page 142
1.
Reinstalling the T320 SCGs on page 143
2.
Reinstalling the T320 Control Boards on page 144
3.
Reinstalling the T320 SIBs on page 145
4.
Reinstalling the T320 Power Supplies on page 146
5.
6. Reinstalling the T320 FPCs on page 147
Reinstalling T320 Front Fan Trays on page 149
7.
Reinstalling the T320 Cable Management System on page 149
8.
To reinstall the rear fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp the fan tray by its handles and insert it straight into the chassis.
2.
Tighten the captive screws on the top and bottom of the fan tray faceplate to secure
3.
it in the chassis.
117.
Figure 52 on page 143):
Copyright © 2018, Juniper Networks, Inc.