Figure 103: Removing A T320 Fpc - Juniper Core Router T Series Hardware Manual

Copyright © 2018, Juniper Networks, Inc.
When the FPC is out of the chassis, do not hold it by the ejector handles
or edge connectors. They cannot support its weight.
Do not stack FPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
If necessary, remove each installed PIC from the FPC.
10.
After you remove each PIC, immediately place it on an antistatic mat or in an
11.
electrostatic bag.
If you are not reinstalling a FPC into the emptied FPC slot within a short time, install
12.
a blank FPC panel over the slot to maintain proper airflow in the FPC card cage.
CAUTION: After removing an FPC from the chassis, wait at least 30
seconds before reinserting it, removing an FPC from a different slot, or
inserting an FPC into a different slot.

Figure 103: Removing a T320 FPC

Chapter 27: Replacing Line Card Components
235