Figure 48: Removing The Rear T320 Fan Tray - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also
136
CAUTION: To maintain proper cooling, do not operate the router with the
rear fan tray removed for more than one minute.
To remove the rear fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the top and bottom of the fan tray faceplate.
2.
Grasp the handles and pull the fan tray halfway out of the chassis.
3.
Place one hand under the fan tray to support it and pull the fan tray completely out
4.
of the chassis.

Figure 48: Removing the Rear T320 Fan Tray

Maintaining the T320 Fan Trays on page 275
Troubleshooting the T320 Cooling System on page 297
Figure 48 on page 136):
Copyright © 2018, Juniper Networks, Inc.