Juniper Core Router T Series Hardware Manual page 144

T320 Core Router Hardware Guide
116
On the rear side of the rack rails, install cage nuts for the large shelf.
On the rear of each rack rail, partially insert a mounting screw into the highest hole
3.
specified for the large shelf in
Install the large shelf on the rack. Hang the shelf over the mounting screws using the
4.
keyhole slots located near the top of the large shelf flanges.
Partially insert screws into the open holes in the ears of the large shelf.
5.
Tighten all the screws completely.
6.
Remove the center-mounting brackets by loosening the screws at the top and bottom
7.
of each bracket.
Optionally, remove the screws the fasten the spacer bars to the front-mounting flange.
8.
The router is shipped with a spacer bar attached to the rear of each front-mounting
flange, and two center-mounting brackets attached to the chassis.
Table 60 on page 115.
Copyright © 2018, Juniper Networks, Inc.