Lift - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
Tools and Parts Required to Install the T320 Router Without a Mechanical Lift
130
To safely install the T320 router without a mechanical lift:
Review the safety information.
1.
See "General Safety Guidelines for Juniper Networks Devices" on page
Installation Safety Guidelines" on page
NOTE: To avoid harm to yourself or the router as you install it, follow the
safety guidelines and procedures for working with routers. However,
providing an exhaustive set of guidelines for working with electrical
equipment is beyond the scope of this documentation.
Verify that the site has been prepared for the router installation.
2.
See "T320 Site Preparation Checklist Requirements" on page
Verify that the mounting hardware has been installed.
3.
See "Installing the T320 Mounting Hardware for a Four-Post Rack or Cabinet" on
page 117 or "Installing the T320 Mounting Hardware for an Open-Frame Rack" on
page 115..
Remove the router from the shipping crate and verify the parts received.
4.
See "Unpacking the T320 Router" on page
Gather the tools required to install the router.
5.
See "Tools and Parts Required to Install the T320 Router Without a Mechanical Lift"
on page 130.
Remove components from the chassis to make it easier to install into the rack or
6.
chassis.
See "Removing T320 Components from the Chassis" on page
Install the T320 Chassis in the Rack Manually. With components removed, the chassis
7.
weighs approximately 131.4 lb (59.6 kg). At least three people are needed to safely
lift the chassis into the rack or cabinet.
See "Installing the T320 Chassis in the Rack Manually" on page
Reinstall the components removed from the chassis.
8.
See "Reinstalling T320 Components in the Chassis" on page
To install the T320 router, you need the following tools and parts:
335.
89.
109.
131.
139.
142.
Copyright © 2018, Juniper Networks, Inc.
327, and "T320