Figure 49: Removing A T320 Fpc - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also
138
Grasp the handles and slide the FPC straight out of the card cage halfway.
6.
Place one hand around the front of the FPC (the PIC housing) and the other hand
7.
under it to support it. Slide the FPC completely out of the chassis, and place it on the
antistatic mat or in the electrostatic bag.
CAUTION: The weight of the FPC is concentrated in the back end. Be
prepared to accept the full weight—up to 19 lb (8.6 kg)—as you slide the
FPC out of the chassis.
When the FPC is out of the chassis, do not hold it by the ejector handles
or edge connectors. They cannot support its weight.
Do not stack FPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
Repeat the procedure for each remaining FPC.
8.

Figure 49: Removing a T320 FPC

T320 Flexible PIC Concentrators (FPCs) Description on page 61
Copyright © 2018, Juniper Networks, Inc.