T320 Core Router Hardware Guide
Reinstalling the T320 Control Boards
144
Figure 53: Reinstalling a T320 SCG
To reinstall the control boards (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Carefully align the sides of the control board with the guides inside the chassis.
2.
Slide the control board into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles and press them inward to seat the control board.
4.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
5.
number 2.
Repeat the procedure to reinstall the remaining control board.
6.
Figure 54 on page
145):
Copyright © 2018, Juniper Networks, Inc.