Related
Documentation
Installing the T320 Chassis in the Rack Manually
Copyright © 2018, Juniper Networks, Inc.
Holding and Storing T320 FPCs on page 278
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Flexible PIC Concentrators (FPCs) Description on page 61
T320 T Series Control Board (T-CB) Description on page 31
T320 Switch Interface Boards (SIBs) Description on page 85
T320 Power System Description on page 83
T320 Cooling System Description on page 25
CAUTION:
If you are installing two routers in one rack, install the lower one
first. Installing a router in the upper position in a rack or cabinet requires a lift.
CAUTION:
Before front mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
CAUTION:
Lifting the chassis and mounting it in a rack requires four people.
The empty chassis weighs approximately 131.4 lb (59.6 kg).
To install the router in the rack (see
Ensure that the rack is in its permanent location and is secured to the building. Ensure
1.
that the installation site allows adequate clearance for both airflow and maintenance.
For details, see
"T320 Site Preparation Checklist Requirements" on page
Attach the installation handle by tightening the captive screws of the handle into the
2.
holes previously occupied by the captive screws of the power supplies (see
Figure 50 on page
140). Tighten the screws, using a Phillips (+) screwdriver, number 2.
Chapter 18: Installing the T320 Without a Mechanical Lift
Figure 51 on page
141):
89.
139