Reinstalling the Fan Trays After Installing the MX960 Router with a Lift
Copyright © 2017, Juniper Networks, Inc.
While firmly pushing the handle on the power supply faceplate with one hand, use
5.
your other hand to pull the spring-loaded locking pin in the release lever away from
the chassis and turn the release lever clockwise until it stops.
Let go of the locking pin in the release lever. Ensure that the pin is seated inside the
6.
corresponding hole in the chassis.
Figure 63: Reinstalling a Power Supply
To reinstall the fan trays (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the fan tray on each side, and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Chapter 16: Installing the MX960 Router
Figure 64 on page 218
and
Figure 65 on page
219):
217