Installing The T320 Router Using A Mechanical Lift - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
T320 Core Router Hardware Guide
Installing the T320 Router Using a Mechanical Lift
126
CAUTION:
Before front-mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
To install the router using a lift (see
Ensure that the rack is in its permanent location and is secured to the building. Ensure
1.
that the installation site allows adequate clearance for both airflow and maintenance.
For details, see
"T320 Site Preparation Checklist Requirements" on page
Load the router onto the lift, making sure it rests securely on the lift platform.
2.
CAUTION:
Do not lift the router using the craft interface, installation
handle, or the handles on the sides of the chassis. Use these handles only
to help position the router.
Using the lift, position the router in front of the rack or cabinet, centering it in front of
3.
the mounting shelves.
Lift the chassis approximately 0.75 in. above the surface of the mounting shelves and
4.
position it as close as possible to the shelves.
Carefully slide the router onto the mounting shelves so that the bottom of the chassis
5.
and the mounting shelves overlap by approximately two inches.
With one person pulling on the installation handle from the rear of the rack or cabinet
6.
while two people push on the front-mounting flanges, slide the router onto the
mounting shelves until the center-mounting brackets or front-mounting flanges
contact the rack rails or spacer bars (depending on your type of installation). The
shelves ensure that the holes in the mounting brackets and the front-mounting flanges
of the chassis align with the holes in the rack rails.
Move the lift away from the rack.
7.
Install the mounting screws:
8.
Four-post rack or cabinet—Install a mounting screw into each of the holes in the
spacer bars.
Figure 42 on page
127):
Copyright © 2018, Juniper Networks, Inc.
89.
Advertisement
Table of Contents
Troubleshooting
