Replacing A T320 Standard Control Board Or T-Cb; Figure 100: Installing A Pc Card - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also
Related
Documentation

Replacing a T320 Standard Control Board or T-CB

228
Press the card firmly all the way into the slot.
4.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
5.
to secure it to the chassis.

Figure 100: Installing a PC Card

T320 RE-600 Description on page 34
T320 RE-1600 Description on page 36
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 RE-600 Description on page 34
T320 RE-1600 Description on page 36
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
The router can have up to two control boards. They are located in the upper rear of the
chassis in the slots marked
To replace a standard control board or T-CB, perform the following procedures:
Removing a T320 Standard Control Board or T-CB on page 229
1.
Installing a T320 Standard Control Board or T-CB on page 230
2.
and . Each weighs approximately 5 lb (2.3 kg).
CB0 CB1
Copyright © 2018, Juniper Networks, Inc.