T320 Core Router Hardware Guide
Related
Documentation
Replacing a DIMM Module in T320 Routing Engines
Removing a T320 DIMM Module
See Also
Installing a T320 DIMM Module
224
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Routing Engine Description on page 33
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
Synchronizing Routing Engines
Removing a T320 DIMM Module on page 224
1.
2.
Installing a T320 DIMM Module on page 224
The DIMM modules are located on the top of the Routing Engine. To remove a DIMM
module:
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Remove the Routing Engine.
3.
Depending on which Routing Engine you are using, there are two different procedures
4.
for ejecting the DIMMs:
For Routing Engines with an ejector on one side of the DIMM, press the plastic ejector
of the DIMM module. The edge of the module raises upward.
For Routing Engines with ejectors on each side of the DIMM, press the plastic ejectors
on both sides of the DIMM module.
Grasp the DIMM module, being careful not to touch any electrical components on the
5.
module, and firmly pull it out of the slot on the Routing Engine.
Place the DIMM module on the antistatic mat or in the electrostatic bag.
6.
Push the plastic ejectors to close the empty DIMM module slot.
7.
T320 Routing Engine Description on page 33
Replacing a T320 Routing Engine on page 215
To insert a DIMM module into the Routing Engine:
Copyright © 2018, Juniper Networks, Inc.