Installing A T320 Routing Engine; Figure 95: Reinstalling The T320 Routing Engine Cover - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also

Installing a T320 Routing Engine

222

Figure 95: Reinstalling the T320 Routing Engine Cover

T320 Routing Engine Description on page 33
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
To install a Routing Engine (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the ejector handles are not in the locked position. If necessary, press the
2.
red tabs and flip the ejector handles outward.
Place one hand underneath the Routing Engine to support it. With the other hand,
3.
grasp one of the ejector handles on the faceplate.
Carefully align the sides of the Routing Engine with the guides inside the chassis.
4.
Slide the Routing Engine into the chassis until you feel resistance, then press the
5.
Routing Engine's faceplate until it engages the midplane connectors.
Press both the ejector handles inward to seat the Routing Engine.
6.
The Routing Engine might require several minutes to boot.
If applicable, tighten the screws on the extractor handles, using a Phillips screwdriver.
7.
Be sure to tighten the screws enough to seat the Routing Engine properly.
Figure 91 on page 219):
Copyright © 2018, Juniper Networks, Inc.