Reinstalling The Fan Tray After Installing The Mx240 Router With A Lift; Figure 57: Reinstalling A Power Supply; Figure 58: Reinstalling A Fan Tray - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Reinstalling the Fan Tray After Installing the MX240 Router with a Lift

180

Figure 57: Reinstalling a Power Supply

To reinstall the fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray on each side and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.

Figure 58: Reinstalling a Fan Tray

Figure 58 on page 180):
Copyright © 2017, Juniper Networks, Inc.