See Also
Related
Documentation
Replacing a T320 PC Card
Copyright © 2018, Juniper Networks, Inc.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the DIMM module from its electrostatic bag.
2.
To open the empty DIMM slot, press the plastic ejectors open.
3.
Grasp the DIMM module by the edges, being careful not to touch any electrical
4.
components.
Pressing firmly on both ends, push the module into the slot until the ejectors return
5.
completely to the closed position.
Install the Routing Engine.
6.
You can view the SDRAM configuration and verify the DIMM was installed correctly
7.
by issuing the
show chassis routing-engine
Figure 98: Installing the DIMM Module
T320 Routing Engine Description on page 33
Replacing a T320 Routing Engine on page 215
T320 Routing Engine Description on page 33
Replacing a T320 Routing Engine on page 215
Removing a T320 PC Card on page 226
1.
Installing a T320 PC Card on page 227
2.
Chapter 26: Replacing Host Subsystem Components
command.
225