Supplies; Figure 42: Installing The T320 Router In The Rack - Juniper Core Router T Series Hardware Manual

Removing the T320 Router Installation Handle and Reinstalling the Power Supplies
Copyright © 2018, Juniper Networks, Inc.
Open-frame rack—Install a mounting screw into each of the open mounting holes
aligned with the rack, starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
9.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.

Figure 42: Installing the T320 Router in the Rack

NOTE: This illustration depicts the router being installed in a four-post rack.
For an illustration of the mounting hardware required for an open-frame rack,
see Figure 37 on page
After you have installed the T320 router, remove the installation handle and reinstall the
two power supplies in the chassis by following this procedure, starting with the lower
power supply (see Figure 43 on page
Chapter 17: Installing the T320 With a Mechanical Lift
117.
128):
127