Installing A T320 Pic; Figure 106: Removing A Pic - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also

Installing a T320 PIC

242

Figure 106: Removing a PIC

Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 PIC Description on page 67
Maintaining T320 PICs and PIC Cables on page 283
Troubleshooting the T320 PICs on page 302
To install a PIC (see Figure 107 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
244):
Copyright © 2018, Juniper Networks, Inc.