Figure 108: Connecting Fiber-Optic Cable To A T320 Pic - Juniper Core Router T Series Hardware Manual

Copyright © 2018, Juniper Networks, Inc.
Insert the other end of the cable into the destination port.
5.
Repeat the previous steps for any additional cables.
6.
If the PIC is offline (its failure indicator LED is lit), use one of the following methods
7.
to bring the PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in a Type 1 FPC, use a tool—such as a flat-blade screwdriver—to press the button
slightly beneath the faceplate of the PIC. For a PIC installed in a Type 2 FPC or a
Type 3 FPC, use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see request chassis fpc.
The normal functioning indicator LED confirms that the PIC is online. You can also
verify correct PIC functioning by issuing the
described in "Maintaining T320 PICs and PIC Cables" on page

Figure 108: Connecting Fiber-Optic Cable to a T320 PIC

Chapter 27: Replacing Line Card Components
show chassis fpc pic-status
283.
command
247