Juniper Core Router T Series Hardware Manual page 146
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
T320 Core Router Hardware Guide
118
To install the mounting shelves and spacer bars:
Install cage nuts, if needed, in the mounting holes specified in
1.
On the front rack rails, install cage nuts in the holes specified for the large shelf and
the spacer bars.
On the rear rack rails, install cage nuts in the holes specified for the small shelf.
On the front of each front rack rail, partially insert a mounting screw into the lowest
2.
hole specified in
Table 61 on page 120
Install the large shelf on the front rack rails. Rest the bottom slot of each flange on a
3.
mounting screw.
Tighten all the screws completely.
4.
The router is shipped with each spacer bar attached to the rear of each front-mounting
5.
flange. Remove each spacer bar by removing the screws that fasten the spacer bar
to the front-mounting flange.
Place one of the spacer bars over a flange of the installed large shelf. Position the
6.
notch in the rear of the spacer bar so the upper part of the bar is flush with the rack
rail and the lower part is flush with the flange of the shelf (see
Insert a mounting screw into each of the nonthreaded holes in the recesses of the
7.
spacer bar to secure the spacer bar. Each hole should have a cage nut behind it.
Repeat Steps
6
and
7
for the other spacer bar.
8.
Tighten all the screws completely.
9.
On the back of each rear rack rail, partially insert a mounting screw into the lowest
10.
hole specified in
Table 61 on page 120
Install the small shelf on the back rack rails. Rest the bottom slot of each flange on a
11.
mounting screw. The small shelf installs on the back of the rear rails, extending toward
the center of the rack. The bottom of the small shelf on the rear rack rails must align
with the bottom of the large shelf on the front rack rails.
Partially insert screws into the open holes in the ears of the small shelf.
12.
Tighten all the screws completely.
13.
Remove the mounting brackets from the chassis by loosening the screws at the top
14.
and bottom of each bracket.
Table 61 on page
for the large shelf and the spacer bars.
Figure 38 on page
for the small shelf.
Copyright © 2018, Juniper Networks, Inc.
120:
119).
Advertisement
Table of Contents
Troubleshooting
