Replacing The T320 Management Ethernet Cables; Figure 65: Removing The Cip - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
Related
Documentation

Replacing the T320 Management Ethernet Cables

180

Figure 65: Removing the CIP

T320 Connector Interface Panel (CIP) Description on page 16
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
To replace the management Ethernet cable:
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 66 on page 181
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
labeled connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
and the ports labeled HOST 1
Engine slot ( ).
RE1
Plug the other end of the cable into the network device.
4.
shows the connector.
connect to the Routing Engine in the lower Routing
Copyright © 2018, Juniper Networks, Inc.
ETHERNET
port. The ports
ETHERNET
),
RE0