To Load A Trace Specification - HP 64782 User Manual

For the graphical user interface

Hide thumbs Also See for 64782:

Table of Contents

Using the Emulation Analyzer

To load a trace specification

Choose File→Load→Trace Spec... In the dialog box, click on the

name of the trace specification you want to load (placing it in the

Load Trace Specification box). Then click OK.

Using the command line, load an existing trace specification from a

file by entering:

load trace_spec <filename>

<filename> is any UNIX file name including paths. The extension .TS is

Once you save a trace specification in a file using the File→Store→Trace

Spec... or store trace_spec command, you can load it using the appropriate

command above. To start a trace with the trace specification that you loaded,

use the Trace→Again or trace again command.

Load a trace specification from a file and start the trace:

load trace_spec tspec