Plugging The Emulator Into A Target System - HP 64782 User Manual

Plugging the Emulator into a Target System

For information about plugging the emulator into a target system,
refer to the 6833x Installation/Service/Terminal Interface Manual.
That manual describes connecting these emulators to a target system
using an AMP 132-pin connector, a PQFP (plastic quad flat pack)
cable, or a 132-pin to PQFP adapter.
•
M68331—Model HP 64782B
•
M68332—Model HP 64782C
•
M68334—Model HP 64782E
•
M68335—Model HP 64782F
It also describes connecting these emulators to a target system
directly using a PQFP cable:
•
M68333—Model HP 64782D
•
M68336—Model HP 64782G
•
M68337—Model HP 64782H
Possible Damage to the Emulator Probe. The emulator contains devices
C A U T I O N
that are susceptible to damage by static discharge. Therefore, precautionary
measures should be taken before handling the emulator probe to avoid
damaging the internal components of the emulator by static electricity.
52