Table of Contents
Advertisement
wait
This command allows you to present delays to the system.
The wait command can be an enhancement to a command file, or to normal
operation at the main emulation level. Delays allow the emulation system
and target processor time to reach a certain condition or state before
executing the next emulation command.
The wait command does not appear on the softkey labels. You must type the
wait command into the keyboard. After you type wait, the command
parameters will be accessible through the softkeys.
The system will pause until it receives a <CTRL>c signal.
Note that if set intr <CTRL>c was not executed on your system, <CTRL>c
normally defaults to the backspace key. See your UNIX system administrator
for more details regarding keyboard definitions.
The parameters are as follows:
measurement
This causes the system to pause until a pending measurement completes (a
_complete
trace data upload process completes), or until a <CTRL>c signal is received.
If a measurement is not in progress, the wait command will complete
immediately.
or
This causes the system to wait for a <CTRL>c signal or for a pending
measurement to complete. Whichever occurs first will satisfy the condition.
seconds
This causes the system to pause for a specific number of seconds.
<TIME>
This prompts you for the number of seconds to insert for the delay.
Emulator/Analyzer Interface Commands
wait
441
Advertisement
Table of Contents
