Table of Contents
Advertisement
Error Messages
Unable to run after CMB break (606)
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
Undefined software breakpoint: %s (605)
Cause: The emulator has encountered a software breakpoint in your program
that was not inserted with the modify software_breakpoints set command.
Action: Remove the breakpoint instructions in your code before assembly
and link.
Unexpected message from emul700dmn
Cause: The host system could not start the emulation session because of an
unexpected message from the HP 64700 emulator process command.
Action: You must press end_release_system to exit this emulation session
completely; then start a new session. Make sure the host system is operating
properly, that all Softkey Interface software has been loaded correctly, and
the data communication switch settings on the emulator rear panel match the
settings in the /usr/hp64000/etc/64700tab.net (or 64700tab) file.
Unexpected software breakpoint (620)
Cause: If you have enabled software breakpoints, this message is displayed if
a software breakpoint instruction is encountered in your program that was
not inserted by a modify software_breakpoints set command and is therefore
not in the breakpoint table.
Action: Remove the breakpoint instructions in your code before assembly
and link, and use the modify software_breakpoints set command to reinsert
them after the program is loaded into memory.
Unexpected step break (621)
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
485
Advertisement
Table of Contents
