Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
step
If the from address option (defined by --EXPR-- or transfer_address) is
omitted, stepping begins at the next program counter address.
The parameters are as follows:
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses specifying a memory address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the
syntax diagram for FCODE to see a list of the function codes available and for
an explanation of those codes.
from
Use this option to specify the address from which program stepping begins.
<NUMBER>
This defines the number of instructions that will be executed by the step
command. The number of instructions to be executed can be entered in
binary (B), octal (O or Q), decimal (D), or hexadecimal (H) notation.
silently
When you specify a number of steps, this option updates the register step
mnemonic only after stepping is complete. This will speed up stepping of
many instructions. The default is to update the register step mnemonic after
each assembly instruction (or source line) executes (if stepping is performed
in the same window as the register display).
transfer_address
This represents the starting address of the program you loaded into
emulation or target memory. The transfer_address is defined in the linker
map.
source
This option performs stepping on source lines.
Examples
step
step from 810H
step 5 source
step 20 silently
step 4 from main
See Also
The display registers, display memory mnemonic, and set symbols
commands.
424
Advertisement
Table of Contents
