HP 64782 User Manual page 57

Starting and Exiting HP 64700 Interfaces
To start the emulator/analyzer interface
Examples
To start the emulator/analyzer interface for the 6833x emulator:
$ emul700 em6833x
The "em6833x" in the command above is the logical emulator name given in
the HP 64700 emulator device table file (/usr/hp64000/etc/64700tab.net).
# Blank lines and
# The information in each line must be in the specified order, with
# for each HP series 64700 emulator.
#
#--------+------------+-----------+-------------------------------------------
# Channel| Logical
# Type | Name
#--------+------------+-----------+-------------------------------------------
# lan: em6833x
serial: em6833x
If you're currently running the X Window System, the Graphical User
Interface starts; otherwise, the Softkey Interface starts.
The status message shows that the default configuration file has been loaded.
If the command is not successful, you will be given an error message and
returned to the UNIX prompt. Error messages are described in the "Error
Messages" chapter.
56
the rest of each line after a '#' character are ignored.
Use blanks or tabs to separate fields.
| Processor | Remainder of Information for the Channel
| Type | (IP address for LAN connections)
m6833x 21.17.9.143
m6833x myhost /dev/emcom23 OFF 9600 NONE XON 2 8
one line